Think of the Atomos Cloud Studio website as being like the virtual back of the system where you would plug everything in, except here once the devices are paired, you will need to add the devices to the show.
Choose Show Type
After tapping on the Live Shows menu, you can choose the feature set for the show you want to use.
If it is your first time here, it is a good idea to play with the demo show, which is a simulation of the fully featured live show package. You can see the full details of what is available in each subscription plan here Atomos Cloud - Plans and Pricing.
Show configuration
Once the show type has been selected, you will be presented with the show configuration page. Under the START button are 4 menu selections running across the top of the page. In each section, there are tiles that represent the slots for adding components to your show.
Adding Devices to the show
When you have selected a show, you will need to add in the devices that you are going to use with the show. Note a device can be listed as part of more than one show, you can only broadcast one show at a time!
This is a simple process, tap on the add device box, for example, 'Add Control Surface 1' and you will be offered a list of the eligible devices that you have added that can perform as a control surface.
Repeat this process for each input and output device that you intend to use on the show.
Once a device is added, tap the tile again, and you can control the configuration of the device in the side panel that appears from the right edge of the browser window. Details of each device configuration are listed below.
Tapping the X in the top right will close the window.
Comments
0 comments
Article is closed for comments.