Adding Devices to your account

Think of the Atomos Cloud Studio website as being like the virtual back of the system where you would plug everything in, except here we pair the devices with ACS.

The pairing process is simple and requires you are logged into ACS and have an Atomos CONNECT device switched on, with the Connect tab in the menu or the application running. In both instances, an unpaired device will display three words used to confirm the pairing process.

On the ACS Devices page, tapping the 'Pair Device (+)' will open a prompt for the three words you can see on your device or application. Enter the three words, using the spelling displayed, and tap next. You can now give your device a nickname, which can be changed later if required. When completed, your device will be added to Atomos Cloud Studio and listed on the devices page.

Once connected on the ACS devices page, you will see a green light displayed next to each active connected device or application.

You will need to repeat this process for each device you want to use on your account.

Note:

• A device can only be paired to a single ACS account, so if it is already paired to another account, you will need to reset the ACS connection on the device or application.
• Change the device's nickname by tapping on the three dots in the top tight corner of the device tile and choose 'Change Nickname'
• You can remove a device by tapping on the three dots in the top tight corner of the device tile and choose 'Unpair Device'