Input Menu - Trigger

Source (Trigger Source)

The SHOGUN CONNECT can be remotely triggered to record from your camera. For HDMI inputs, tap Source to cycle through the following trigger sources:

• HDMI: If HDMI timecode is selected, you have the choice to start and stop recording remotely from the source camera timecode.

• None: Select to disable the record trigger.

• Timecode: For older cameras or cameras that don’t have Start/Stop flags for triggering recording, the rolling timecode trigger will trigger recording automatically on the SHOGUN CONNECT when it detects rolling timecode on the camera.

• Camera Manufacturer: When you have an SDI signal connected to your SHOGUN CONNECT, and have selected SDI at Input, you will be able to tap Source to cycle through camera manufacturers as well as Timecode or None as the source of a trigger.

Trigger (On/Off)

Where you have selected Timecode as the trigger source, you can enable or disable the trigger by tapping the ON/OFF switch.

Note that where you have selected a camera manufacturer, you cannot disable the trigger