Powering On and Off

Power Button

The Power button is located on the top left hand side of the unit (as you look at the screen). With a power source connected, momentarily press the Power button. After a couple of seconds you will see the ATOMOS logo then the SHOGUN CONNECT Home Screen.

Selecting the AirGlu module region

The first time you power on your SHOGUN CONNECT, you will be prompted to select your region of use. Tap region to cycle through the options and then tap on Confirm. This message will also appear after performing a factory reset and after installing new AtomOS firmware.

You are not permitted to select a region that is different to the region where you are using the device.

Turning OFF power to the SHOGUN CONNECT

To turn the unit off, tap the battery icon on the top right of the home screen to open the Power menu screen.

On the Power menu screen press the green Power icon for 4 seconds.Four seconds can seem like a long time, but this is intentional to make sure that the SHOGUN CONNECT can’t be turned off accidentally.

The icon will turn red when touched to indicate activation of the button. The unit will then power off. You can also do a forced power down by pressing the physical Power button on the side of your SHOGUN CONNECT for four seconds. For more information on the Power menu see the Power Down.

Do not press and hold the power button in on the SHOGUN CONNECT while the unit is off. This will place the device in to a Firmware recovery mode. If you accidentally do this, simply turn the device off again or remove the power source.

Take note to respect the air flow and do not obstruct the cooling vents of the unit.