When the Atomos CONNECT is attached to your NINJA V+ and the device is in Connect Mode, the Ethernet menu tab will appear in the menu system. This menu provides settings for connecting your device to a network via Ethernet, so that you can connect to Atomos Cloud Services. For more information on Connect Mode refer to the CONNECT MODE section.
An Atomos CONNECT must be attached to your NINJA V+ and the device must be in Connect mode before the Ethernet Menu page appears in the menu system.
How to connect to an Ethernet network
Plug an Ethernet cable from your network into the Ethernet connector on your Atomos CONNECT.
Navigate to the Ethernet Menu page on your NINJA V+.
Tap on IP Configure to cycle through DHCP and Static. Select DHCP to configure the network connection details automatically. Your router will then automatically populate the DNS, IP address and Subnet Mask fields.
To use DHCP, your network needs to have DHCP enabled, so that it can automatically assign an IP address.
If you prefer to manually configure the network, select Static at IP Configure. Tap in one of the empty fields and a keyboard will appear so that you can enter the IP address, Subnet Mask and Router. Tap Confirm once you have finished entering these details.
Once you have connected to an Ethernet network, a green circle and the word Connected will be displayed at Ethernet. The device MAC address will also be displayed.
The Connect Menu page will be updated with a green circle and the word 'Connected' at Network. Refer to the CONNECT MODE section for information on connecting to the Atomos Cloud.
It may take up to 10 seconds for Ethernet connections to be re-established when switching between record and playback mode.