Source Menu

The Source menu allows you to select your Input Source, depending on your signal connection and how you are using your NINJA V.

Select your Input Source

Select your Input Source from the options below. Once you have made a selection, tap OK and your NINJA V will power down and reboot in the selected mode. Press cancel to return to the selection screen.

HDMI

Selects the HDMI input on your NINJA V. This mode should be used for standard NINJA V operation when you do not have AtomX CAST connected.

SDI

For SDI sources connected to an AtomX SDI Module or ATOMOS CONNECT that is attached to your NINJA V. To be available for selection, an an AtomX SDI Module or ATOMOS CONNECT needs to be connected before turning on the NINJA V.

AtomX CAST

Select to use the features of the AtomX CAST. To be available for selection, the AtomX CAST module needs to be connected to the NINJA V before powering it on.

When AtomX CAST is connected to your NINJA V, the AtomX SDI option will be greyed out since you cannot use the SDI module when the AtomX CAST is attached.

RAW inputs are not supported when using the AtomX CAST for switching.

If you power on NINJA V after using the AtomX CAST mode, you may see a warning notifying you that an AtomX CAST module has not been detected. You will be advised to Power Off your NINJA V and attach the module, or to change modes and operate without the module.